Table of Contents
Advertisement
Electrical system
Assembly and maintenance work
Check electrical wiring for visible damage
Electrical connections and distributors:
Check terminal boxes for damage
5.3
Maintenance log
The required maintenance intervals are dependent on the intensity of use of the system at the
owner's deployment site and the consequent signs of wear. In order to be able to adjust the
maintenance intervals of these terms of use, the general condition of the system as a whole as well
as the assemblies and components must be logged in detail during the regular and (if required)
unscheduled maintenance work.
Observe the following when creating maintenance logs:
▪
Produce a maintenance log for each maintenance task and log all performed maintenance
work.
▪
Store the maintenance logs.
5.4
Repair
Incorrect repair work impairs the operational safety. This can cause accidents and seriously injure
people as a result.
Observe the following:
▪
Repair work may only be carried out by the manufacturer or authorized specialist personnel.
▪
Switch off the system and secure it against being switched back on before all repair work.
▪
Switch off the compressed air system and secure it against being switched back on.
Depressurize the compressed air-conveying components. Check if the pneumatic system has
been relieved of pressure.
▪
Work on the electrical system may only be carried out by trained electricians.
▪
For all work on the electrical system, switch off the voltage supply and secure it against being
switched back on again by accident.
▪
Only use original spare parts.
In case of repairs at the conveyor system, the customer service will help (see page 4: Customer
service).
Spare parts can be ordered directly from the manufacturer (see page 8: Spare parts and their
purchase).
Personnel
Specification
Personnel
Quick installation guide_Conveyor system MB-flex O Al_20221114_EN.docx
Interval [Bh]
40
170
Designation
Maintenance personnel
Maintenance
23
Personnel
Electricians
Electricians
Advertisement
Table of Contents
