Table of Contents
Advertisement
6
Safety
2.3
Instruction of the personnel
Each person assigned to carry out work must, before commencing, receive instruction from the
owner regarding their delegated activities and potential dangers during work.
For instruction, observe the following:
▪
Repeat instruction at regular intervals.
▪
Verifiably log each personnel instruction session.
2.4
Qualification requirements
Safety note: Risk of injury due to insufficient qualification.
If the conveyor system is used improperly, property damage may occur, or persons may be injured
or killed.
»
All activities may only be carried out by personnel who have the required training,
understanding regarding the functioning of the conveyor system and the relevant experience.
Furthermore, special qualifications are required for certain tasks. These are defined as follows.
2.4.1
Specially trained personnel
Specially trained personnel are persons who have been instructed on the tasks delegated to them
and their potential dangers by the owner.
2.4.2
Operating personnel
Operating personnel are persons who have been instructed on the tasks delegated to them and their
potential dangers by the owner. The operating personnel are capable of operating the conveyor
system independently. The operating personnel have been instructed regarding possible dangers in
the event of improper behaviour. Cleaning and control tasks on the conveyor system are carried out
independently.
2.4.3
Maintenance personnel
Maintenance personnel are persons who, as a result of their technical training (e. g. mechanical,
electrical, pneumatic), knowledge, experience and awareness of pertinent norms and provisions, are
capable of correctly carrying out their delegated tasks. Maintenance personnel are capable of
recognizing potential dangers independently, and consequently avoiding them.
2.4.4
Qualified specialist personnel
Qualified specialist personnel are persons who have obtained and proven special experience,
knowledge and skills for the safe performance of tasks in particular specialist areas (e. g.
mechanical, pneumatic, hydraulic, electrical) and who fulfil the following defined requirements.
Quick installation guide_Conveyor system MB-flex O Al_20221114_EN.docx
Advertisement
Table of Contents
