Table of Contents
Advertisement
Cleaning
4
This chapter provides information on the execution of the operating mode Cleaning:
▪
Personnel and Protective equipment (Page 17)
▪
Selection of the cleaning agent (Page 17)
▪
Preparation (Page 18)
▪
Execution (Page 18)
ATTENTION
Warning of material damage due to improper cleaning!
Improper cleaning leads to damage to the system or its surroundings.
»
Cleaning the system according to the instructions in this installation guide.
»
Do not use steam jet or high-pressure cleaning devices for cleaning surfaces.
»
Do not use compressed air for cleaning and drying surfaces.
4.1
Personnel and Protective equipment
Personnel and Protective equipment
Specification
Personnel
Personal protective equipment
4.2
Selection of the cleaning agent
The cleaning agents used are specified by the local hygiene officer.
Observe the cleaning agent manufacturer's instructions.
Furthermore, observe the following:
Find application:
▪
Solutions with a pH value between 4.5 and 9
▪
Water with a pressure of 10 to 20 bar
▪
Water with temperatures from 52°C to 54°C
Find no application:
▪
Cleaning products containing chlorine, ammoniac, phosphoric acid or their compounds
▪
Abrasive cleaning products
▪
Solutions with a pH value below 4.5 or above 9
▪
Water with a pressure above 20 bar
▪
Water with temperatures above 54°C
Quick installation guide_Conveyor system MB-flex O Al_20221114_EN.docx
Designation
Operating personnel
Protective equipment against the cleaning agents used
according to the instructions of the manufacturer of the
cleaning agents
Cleaning
17
Advertisement
Table of Contents
