3.5-Inch Hard Drive - Dell OptiPlex Small Form Factor 7010 Owner's Manual

Steps
1. Insert and align the hard drive into the hard-drive carrier.
2. Replace the four screws (M3x3) that secure the hard drive to the hard-drive carrier.
3. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier into place.
4. Replace the screw (#6-32) to secure the hard-drive carrier to the chassis.
5. Connect the data and power cables to the connectors on the hard drive.
Next steps
1. Install the side cover.
2. Follow the procedure in

3.5-inch hard drive

Removing the 3.5-inch hard drive
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the 3.5-inch hard-drive assembly and provide a visual representation of the
removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 43