Installing The Graphics Card - Dell OptiPlex Small Form Factor 7010 Owner's Manual

2. Push and hold the securing tab on the graphics-card slot and lift the graphics card from the graphics-card slot

Installing the graphics card

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the graphics card and provides a visual representation of the installation procedure.
Steps
1. Align the graphics card with the PCIe x16 card connector on the system board.
2. Using the alignment post, connect the card in the connector and press down firmly. Ensure that the card is firmly seated.
3. Rotate the graphics-card support bracket that connects the graphics card.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard drive
64 Removing and installing Customer Replaceable Units (CRUs)
if applicable.