Dp Module - Dell OptiPlex Small Form Factor 7010 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor 7010:
- Owner's manual (119 pages) ,
- Owner's manual (119 pages) ,
- Owner's manual (119 pages)
Table of Contents
Advertisement
Steps
1. Using a screwdriver, remove the VGA module cover from the chassis.
NOTE:
This step is applicable only when the VGA module is being installed for the first time.
2. Connect the VGA-module cable to the connector (VIDEO) on the system board.
3. Insert the VGA module into the slot on the chassis.
4. Replace the two (M2x5) cross type screws to secure the VGA module to the chassis.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
DP module
Removing the DP module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following image indicates the location of the DP module and provides a visual representation of the removal procedure.
90
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex Small Form Factor 7010 and is the answer not in the manual?
Questions and answers