Wireless Card; Removing The Wireless Card - Dell OptiPlex Small Form Factor 7010 Owner's Manual

NOTE: The thermal pad is re-usable. The thermal pad is pre-installed on systems shipped with solid-state drive. If the
solid-state drive is purchased separately, the thermal pad is not bundled with the solid-state drive kit and is to be
purchased separately.
2. Peel off the protection mylar on the thermal pad.
3. Align the notch on the M.2280 solid-state drive with the tab on the M.2 card slot on the system board.
4. Slide the M.2280 solid-state drive into the M.2 card slot on the system board.
5. Replace the screw (M2x3.5) to secure the M.2280 solid-state drive to the system board.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard drive
3. Install the 2.5-inch hard drive
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in

Wireless card

Removing the wireless card

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
About this task
The following image indicates the location of the wireless card and provides a visual representation of the removal procedure.
60 Removing and installing Customer Replaceable Units (CRUs)
if applicable.
if applicable.
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.