Banner SureCross DX80 Product Manual page 38

Setting the Slave ID, Baud Rate, and Parity
Similar to Network ID, the Slave ID, Baud Rate, and Parity parameters can be changed in the Device Configuration (*DVCFG) system menu
option.
Follow the top level system menu through *DVCFG to the Slave ID (SLID) parameter. The LCD displays an alternating current value and new
value for the parameter.
On the Gateway or Gateway Pro, single-click button 1 to move
across the top level menu options to the *DVCFG (Device
Configuration) menu
Single-click Gateway push button 2
Single-click Gateway push button 1 to move to the Slave ID field.
Single-click Gateway push button 2
Using 0-9 on the left rotary switch and 1-9 on
the right switch, set the rotary switches to the
desired Slave ID
Single-click Gateway push button 2 to save the new Slave ID.
Single-click Gateway push button 1 to move to the next menu
option, the BAUD rate.
Single-click Gateway push button 2 to display the current setting.
Single-click Gateway push button 1 to cycle through the available
options. Stop on the desired setting.
Single-click Gateway push button 2 to save the new setting.
Single-click Gateway push button 1 to move to the next field, the
PARITY field.
Single-click Gateway push button 2 to display the current setting.
Single-click Gateway push button 1 to cycle through the available
options. Stop on the desired setting.
Single-click Gateway push button 2 to save the new setting.
Adjust the left rotary switch back to NID value.*
Adjust the right rotary switch back to zero.
Double-click Gateway push button 2 to return to the Device
Configuration (*DVCFG) menu.
Click Gateway push button 1 until reaching the *RUN menu
option.
* To avoid losing the network connection between the Gateway and Nodes, reset the rotary switches back to their appropriate values before leaving the *DVCFG sub-menus. If the Gateway and Nodes lose their connection, the
network may take up to 20 seconds to re-synchronize.
38
P/N 132607
User Action Display / Status
To navigate to the *DVCFG (Device
Configuration) menu, see the
device menu layout in the Setup
- Wireless Network section.
Default value is 1
The new Slave ID is defined by
the current position of the rotary
switches.
Select between 01 to 99. The
factory default is set to 1. Change
the Slave ID when running more
than one network into the Modbus
Master device.
The options are 9600, 19200,
38400. The factory default is 19200.
The options are NONE, EVEN,
ODD. The factory default is NONE.
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Notes