Siemens 9410 Series User Manual page 57

Communications
7EN05-0336-03
IPv4 settings available using the webpages
Parameter
IPv4 Assignment mode
Stored IPv4 address
Stored IPv4 Subnet Mask
Stored IPv4 Gateway
The webpage also displays the acquired IPv4 settings if the Assignment mode is set to DHCP.
NOTE: To disable communications using IPv4, set the Assignment mode to Stored and the IPv4
Address to 0.0.0.0.
IPv6 settings available using the webpages
Parameter
IPv6 Assignment Mode
IPv6 Link Local Addess
Stored IPv6 Global Address
Stored IPv6 Gateway
The webpage also displays the acquired IPv6 settings if the Assignment mode is set to DHCP.
NOTE: To disable communications over IPv6, set Enable IPv6 in Advanced Settings to "No".
NOTE: You must enclose an IPv6 address in square brackets when typing it in a web browser, for
example: "http://[fe80::260:78ff:fe04:5943]".
Configuring IPv4 / IPv6 communications settings using ION Setup
You can configure your device's IPv4 and IPv6 address settings, such as stored
addresses or address assignment mode, using ION Setup.
When configuring communications parameters, ensure you maintain at least one
communication path that allows full access to your device; otherwise you may
permanently lose the ability to change your device's configuration and access
additional data.
Value
Stored
DHCP
Contact your local network
administrator for parameter
values.
Contact your local network
administrator for parameter
values.
Contact your local network
administrator for parameter
values.
Value
Stored
DHCPv6
Read-only
Contact your local network
administrator for parameter
values.
Contact your local network
administrator for parameter
values.
9410 series
Description
Stored: The meter uses the IP
addresses that you manually
enter for IPv4 (address, subnet
mask and gateway).
DHCP: The meter acquires its IP
addresses from your network's
DHCP server.
The Internet protocol address of
your device.
The Ethernet IP subnetwork
address of your network.
The Ethernet IP gateway
address of your network.
Description
Stored: The meter uses the IP
addresses that you manually
enter for IPv6 (Global address,
gateway address).
DHCPv6: The meter acquires its
IP addresses from your
network's DHCP server.
TheIPv6 Link Local address is
factory set and is read-only.
The Internet protocol address of
your device.
The address the meter uses to
route communications to a
different network or subnet. If
you do not set this or the address
is incorrect, you may see slow
communications or
communications errors.
57