AMQ Activ User & Troubleshooting Manual page 8

Setting a Custom Minimum Height
1 . Use the DOWN button to move the base to the desired minimum-height position .
2 . Press the "M" button and release . The LED display will show "S- '' .
3 . Then press the "DOWN" button and release .
4 . Then press and hold the "M" button until the LED display will show "000" . The new minimum height is
now set .
Removing the Custom Height Positions
1 . Press and hold the "M" button until the LED display flashes "S -" and then release it .
2 . Press the "M" button again and hold for 2 seconds . The LED display will change to "555" and then
automatically return to the height display . The upper and lower limits are now removed .
Note: A RESET procedure requires the desk base to full retract (beyond any lower limit set) .
Changing LED Number between inches and centimeters
1 . Press the DOWN button on the Handset until the base reaches its lowest position .
Press and hold the DOWN button again until the LED display reads "ASR" .
2 . Press and hold the "2" button (about 5 seconds) while the LED flashes "ASR" and then switches to either:
10 .3 = cm
10 .4 = inches
3 . Release the "2" button for the display to return to "ASR" .
4 . Finish the reset process by pressing and holding the DOWN button until the desk lowers a little bit more,
slightly rises and stops . Release the button . The new setting is saved and your desk is now ready to use .
For questions or support, please contact AMQ Customer Care at
Activ-Pro User / Troubleshooting Guide | 8
cc@amqsolutions .com or (877) 801-0370 .
amqsolutions.com