User Guide (Activ Pro / Pro3) - AMQ Activ User & Troubleshooting Manual

User Guide
A
Programming Memory Presets
1 . Press the up or down arrow to set the worksurface to the desired height .
2 . Press "M" button followed by one of the preset number buttons (1, 2 or 3) on the LED screen .
3 . The table will automatically reset to this height whenever the preset number is pressed and
preset height is reached .
Power Saving Mode - Waking up the Hand Set
1 . Press any button to wake up handset .
Resetting the Base
Note: Make sure there is nothing under the base before setting to its lowest level (24 .5") .
!
If the cable is obstructed it will not reset properly .
1 . Press and hold the Down arrow; the desk will begin to go down .
2 . Once the desk reaches its lowest height, continue to press the Down arrow for 5 seconds, until the digital
display shows "RST" .
3 . Release and then press the Down arrow again; the recalibration process will now begin .
4 . When reset is complete, the digital display will show "24 .5" .
Hard Reset for E07/E08 (If base is half way or full standing position)
1 . Press on the down button and hold until you see ASR code and release .
2 . Immediately after releasing down button, press and hold down button again, the base will slowly go down .
3 . Hold the down button until the base hits bottom, keep holding down button and wait for the base to bump up .
4 . Release when you see height numbers . Your base is reset .
*Previous versions of ACTIV have "press and go" technology and don't require the hold of a button to reach
pre-programmed heights .
Activ-Pro User / Troubleshooting Guide | 6
A . Height Adjustment Buttons
B . Memory Position Buttons
C . Memory Setting Button
D . Digital Display
B
C
D
held* until the
amqsolutions.com