Table of Contents
Advertisement
7. PARAMETER PAGES
in the MATRIX parameter page. Select LFO 1ST as a source and then select modulation destination
and modulation depth. For more information, please see "7.4.9 MATRIX" on page 36.
2. The second destination is set in the MATRIX parameter page (see above). Select LFO 2ND as a
source and then select modulation destination and modulation depth.
3. The third modulation destination is permanently set to the filter cutoff. The amount of LFO mod-
ulation added to the filter cutoff is controlled by the parameter LFO on the FILTER/EQ PAGE 1
parameter page.
FADE offers the possibility to fade in/out the LFO modulation. Positive values give a fade-out, negative
values give a fade-in. A middle position (0) results in no fade in/out. The fade curve is restarted each
time the LFO triggers.
MODE Selects between five different modes of LFO behavior.
• FREE is the default free-running mode. The LFO run continuously, never restarting or stopping.
• TRIG The LFO run continuously, but restarts on the event of an envelope trig.
• HOLD The LFO run continuously, but on the event of an envelope trig, the output LFO level is
latched and held still until the next envelope trig
• ONE The LFO starts when a note is trigged, then runs to the end of the waveform and then
stops. This makes the LFO function similar to an envelope.
• HALF The LFO starts when a note is trigged, then runs halfway through the waveform and then
stops.
DEST1 Sets the first modulation destination of the LFO. For more information, please see "APPENDIX
B: MODULATION SOURCES AND DESTINATIONS" on page 44.
DEPTH1 Sets the amount of how much the LFO affects the modulation destination. A negative value
gives an inverted modulation.
7.4.5 LFO2 PAGE 1
This page contains the same parameter as LFO1 PAGE 1 but instead controls LFO2.
7.4.6 LFO2 PAGE 2
This page contains the same parameter as LFO1 PAGE 2 but instead controls LFO2.
7.4.7 LFO3 PAGE 1
This page contains the same parameter as LFO1 PAGE 1 but instead controls LFO3.
7.4.8 LFO3 PAGE 2
This page contains the same parameter as LFO1 PAGE 2 but instead controls LFO3.
7.4.9 MATRIX
On the Modulation Matrix page you can connect a number of modulation sources with their destinations
and set the modulation depth. For more information, please see "APPENDIX B: MODULATION SOURCES
AND DESTINATIONS" on page 44.
1. Turn the leftmost DATA ENTRY knob to scroll through the source list and select the source.
2. Turn the third DATA ENTRY knob to scroll through the destination list and select the destination.
3. Lastly, use the rightmost DATA ENTRY knob to set the modulation depth.
36
Advertisement
Table of Contents
