Bits; Warble; Compressor - Elektron Analog Heat +FX User Manual

7. PARAMETER PAGES
7.3 FX
Press [FX] to access these parameter pages.

7.3.1 BITS

SRR (Sample Rate Reduction) sets the amount of sample rate reduction.
BR (Bit Reduction) sets the bit rate. The parameter range is from 16 bits to 2 bits.
FLTR Filter for the SRR and BR effects. The parameter ranges from a low-pass filter to a high-pass
filter. Negative parameter values set a low-pass filer. Positive parameter values set a high-pass filter.
MIX Sets the mix between the clean signal and the signal that is affected by the effect.
7.3.2 WARBLE PAGE 1
DEPTH Sets the depth of the warble effect
SPEED Sets the speed of the warble effect: A setting of 0 makes the speed random.
BASE Sets the base frequency of the filter.
WIDTH Sets the frequency width above the base frequency.
7.3.3 WARBLE PAGE 2
N LEV Noise Level sets the amount of noise that is added to the effect.
HPF High-pass filter sets the frequency for the highpass filtering of the noise.
STEREO Stereo Width sets the amount of the warble effect in the stereo field.
MIX Sets the mix between the clean signal and the signal affected by the effect.
7.3.4 COMPRESSOR PAGE 1
The Compressor compresses the dynamic range of the signal by reducing the volume of loud sounds
relative to the quiet sounds. The screen shows the input/outputs signals and the gain reduction.
28