Delay - Elektron Analog Heat +FX User Manual

PING Ping-pong sets the delay signal to alternate across the stereo field. There are two settings:
OFF lets you manually set the position of the delay signal in the stereo field. Use the WID parameter
to change the stereo field position.
ON makes the delay signal alternate between left and right pan positions. The WID parameter
controls the amount of panning.
WIDTH Stereo Width sets the delay signal pan width across the stereo field. The knob is bipolar.
FDBK Feedback Gain sets the amount of delay output signal to feed back into the input of the delay.
With higher parameter settings, infinite and swelling delays are possible. Please be aware that high
feedback can lead to a very loud signal.
7.3.9 DELAY PAGE 2
HPF Sets the cutoff frequency of the delay highpass filter.
LPF Sets the cutoff frequency of the delay lowpass filter.
MODE Sets what the AMOUNT parameter controls.
SEND In this mode, AMOUNT controls the level of the dry signal sent to the delay.
RETURN In this mode, AMOUNT controls the level of the wet signal returning from the delay.
MIX In this mode, AMOUNT controls the mix of the dry and wet signals.
AMOUNT Sets the amount of signal sent to or from the delay depending on the selected MODE.
TIME setting Divide ratio
10.67 1/12 (1/8T)
12 1/16.
16 1/8
21.33 1/6 (1/4T)
24 1/8.
32 1/4
42.67 1/3 (1/2T)
48 1/4.
64 1/2
96 1/2.
128 1
A

Delay

A
Delay
+A
-A
Delay
7. PARAMETER PAGES
+
+
+
31