Table of Contents
Advertisement
Reassembly
The kit includes a motor coupler (28a) for a NEMA
184 TC Frame electric motor.
To install an IEC 112M/B5 Frame electric motor,
order Motor Adapter Kit 15J893. See manual
311605.
1. See F
. 7. Apply antiseize lubricant to bore of cou-
IG
pling.
15
Apply antiseize lubricant to bore of coupling (28).
20
105
F
. 7. Motor Coupler Installation
IG
When installing an IEC 112M/B5 Frame electric
motor, ensure that the motor adapter (60) and
screws (59) are in place before mounting the motor
on the gear reducer. See F
6
28a
ti8913a
15
. 5.
IG
CAUTION
If installing an IEC 112M/B5 Frame electric motor
which is not supplied by Graco, ensure that the motor
shaft key cannot move out of position. If the key works
loose it could cause excessive heat and equipment
damage.
2. Lift the motor (19) into position. Align the key on the
motor shaft with the mating slot of the motor cou-
pler, and the four mounting holes with the holes in
the gear reducer (1). Slide the motor into place.
3. While one person supports the motor (19), install
the screws (37*). Torque to 75-80 ft-lb (102-108
N•m).
4. See F
. 6. Screw the slider cylinders (2) into the
IG
new gear reducer (1). Torque to 15-20 ft-lb (21-27
N•m). Install the setscrews (31). Torque to 30-35
in-lb (3.4-3.9 N•m).
5. Screw the tie rods (3) into the gear housing. Torque
to 50-60 ft-lb (68-80 N•m).
6. Orient the lowers (22) to the gear reducer (1) as
shown. Position the lowers on the tie rods (3). Screw
the tie rod locknuts (15*) onto the tie rods. Torque
the locknuts to 50-60 ft-lb (68-80 N•m).
7. See F
. 8. Ensure that the joints between the slider
IG
bearings (8) align with the pin hole (PH) in the slider
piston (9).
8. Slide the piston (9) and connecting rod (7) into the
cylinder (2).
9
8
F
. 8. Slider Bearings
IG
Kit Installation
7
8
PH
ti8719a
311615A
Advertisement
Table of Contents
