Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Graco 15H882
Summary of Contents for Graco 15H882
- Page 1 Instructions 15H882 Slider Bearing Kit 311616D ® To replace slider bearings on E-Flo 4-Ball Piston Pumps. For professional use only. Important Safety Instructions Read all warnings and instructions in this manual and in E-Flo Repair-Parts manual 311594. Save these instructions.
- Page 2 (3). tion before pressurizing system again. Kit Parts NOTE: Slider Bearing Kit 15H882 includes parts to rebuild both slider bearing assemblies. Parts included in the kit are marked with an asterisk, for example (5*). Use all the new parts in the kit.
- Page 3 Kit Installation 5. Place a clean rag over the top of the slider cylinder 10. See F . 3. Rotate the crank arm (4) to allow it to be (2) to prevent debris from falling into the slider removed from the output shaft (OS). assembly during disassembly.
- Page 4 Kit Installation Reassembly 8. Install the shields (72) by engaging the bottom lips with the groove in the wet-cup cap. Snap the two shields together. 1. See F . 4. Install the two new bearings (8) on the slider piston (9). The joints between the bearings 9.
- Page 5 Kit Installation 311616D...
- Page 6 With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.
Need help?
Do you have a question about the 15H882 and is the answer not in the manual?
Questions and answers