Table of Contents
Advertisement
ActiveScale™ OS X100 Rackless Installation Guide
1. Connect an Ethernet cable from your laptop to port 44 on System Interconnect 1.
2. Configure your computer to be on the same network as the System Interconnect using the following
values:
– Management Port: 192.168.123.0/24
– Subnet: 255.255.255.0
– Gateway: 192.168.123.123
3. Open a Telnet session to the System Interconnect and replace switchport_IP with the default
IP address 192.168.123.123.
The System Interconnect command prompt appears.
4. Log in using the default credentials:
– User name: admin
– no password
5. Type enable to enter the Privileged EXEC command mode.
Routing
(
6. Type configure to enter the Privileged CONF command mode.
Routing
(
Routing
(
7. Open the required ports for the System Expansion Node:
Important: If you are installing more than one System Expansion Node, open
the necessary ports on both System Interconnects before continuing to the next
node.
d.
System Expansion Node 1
en
conf
interface 0/38
no shutdown
exit
exit
write memory confirm
Config file 'startup-config' created successfully. Configuration Saved!
enable
)>
configure
)#
Config
) (
)#
214
Advertisement
Table of Contents
