Danfoss Optyma iCO2 User Manual page 4

User Guide | Optyma™ iCO2
(b) Display priority
1. Display priority is as shown by the following table.
Priority
Receiving of line check command
ROM version display
High ↑
Error display
↓
Operation code display
Low
Compressor oil check operation display
Ordinary channel display
2. If the state of the display at 1 is released, it changes to the auto display.
3. If SW8 or SW9 is pressed in the display at 1, it changes to display [C00].
4. However, if the switch is not pressed for 10 seconds, it displays by the priority of 1).
5. Display change : Special display shows other than CXX, PXX and FXX.
* If the special display is released in this period, [CXX] or [PXX] continues.
* If the special display is released in this period, [CXX] or [PXX] continues.
4 | BC408445719305en-000101
If specialdisplay occurs.
[CXX]
Button operation
No operation for 10 sec.*
Button operation
Display content
[QO]
[WLMC], or other
[Exx]
[oPE-X]
[oil]
[Cxx][Pxx][xx]
Special display
Special
display
release
Auto feed
C9
© Danfoss | Climate Solutions | 2023.01 | LCA012A030