Stairville LED Flood Panel 150 20 User Manual page 29

Operating mode 'Auto'
Operating mode 'Slave'
Settings for programmes 02 to 10:
After colour selection, press [Setup] to set the programme running speed. The display shows
'SP.xx' . Use [Up] and [Down] to select a value between 'SP.01' (slow) and 'SP.99' (fast) or 'SP.FL'
(strobe effect).
To set the flash frequency for the strobe effect, press again [Setup]. The display shows 'FSxx' .
Use [Up] and [Down] to select a value between 'FS00' (slow) and 'FS99' (fast).
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Mode] repeatedly until the display shows 'Auto' . All available programmes are played in
an endless loop, playback starts automatically.
Press [Setup] to set the programme running speed. The display shows 'SP.xx' . Use [Up] and
[Down] to select a value between 'SP.01' (slow) and 'SP.FL' (fast).
To set the flash frequency for the strobe effect, press again [Setup]. The display shows 'FSxx' .
Use [Up] and [Down] to select a value between 'FS00' (slow) and 'FS99' (fast).
To adjust the fade function, press again [Setup]. The display shows 'Fdxx' . Use [Up] and [Down]
to select a value between 'Fd00' (slow fading) and 'Fd99' (fast fading).
This setting is only relevant if the device is working as Slave in a Master / Slave configuration
and is not controlled via DMX.
Press [Mode] until the display shows 'SLAv' .
LED Flood Panel 150 20°, LED Flood Panel 150 40°
LED Floodlight
Operating
29