Sage Oracle Instruction Booklet page 13

PAGE HEADER..... OPERATING YOUR NEW APPLIANCE
• Fill the water tank with cold water before
sliding back into position at the back of the
machine and locking into place.
NOTE
Replacing the water filter after three months
or 40L will reduce the need to descale the
machine. For information on purchasing
additional filters visit sageappliances.com
FIRST USE
Ensure tank is filled with cold water.
1.
You can do this by either opening the
top-fill water tank lid (push to open),
or by removing the water tank at the back
of the machine.
Press POWER button to turn machine on.
2.
The main LCD will display 'Hrd3',
3.
prompting you to set the water hardness
level. Programming this will determine the
regularity of the 'DESCALE' and 'CHANGE
FILTER' alerts.
Setting Water Hardness
• Remove the supplied water hardness
test strip from the wrapper.
• Dip the test strip into a sample
of the water you have filled the
tank with. Wait for one minute.
The water hardness setting is
indicated by the number of red
squares displayed on the test
strip eg. 3 red squares indicates
a water hardness setting of 3.
• Rotate SELECT dial to the required
setting from 'Hrd1' (softest water)
to 'Hrd5' (hardest water). Press
SELECT dial to set. Machine will
beep once to confirm selection.
A pumping/vibrating sound will be
4.
heard indicating empty boilers are
being filled with water for the first
time. The main LCD will display the
current boiler temperature and flash
'HEATING'.
After approximately 5 minutes, the
5.
machine will reach the default
operating temperature 93˚C and all
6 buttons will illuminate. The machine
is now in STANDBY mode, ready for
the next step, 'Flushing The Machine'.
POWER SELECT
TEMP TEXTURE
HOT WATER LONG BLACK
13