Advertisement
nFORCE™ LED Lightbar - 24"
Driver Side End Tub
REPLACEMENT OF INBOARD AND CORNER MODULES:
1. Disconnect main power.
2. Remove top cover by removing screws.
3. Locate module and remove mounting screws. Pull or slide module from lightbar.
4. Remove connector from rear of module by carefully pulling connector body from back of module.
5. Push module connector into replacement module ensuring locking latch is seated properly or connector is fully seated.
6. Replace module and hardware that fasten module to base extrusion.
7. Restore power to bar and test new module to ensure functionality.
8. Replace top cover of bar with screws removed in step 2.
Driver Module Replacement:
a. Verify power has been removed from lightbar before attempting service
b. Remove top cover
c. Unplug 3 pin power/data connector and LED module connectors from driver module assembly, noting location.
d. Remove driver module
e. Snap new driver module assembly into housing
f. Plug 3 pin power/data connector and LED module connectors into driver module assembly
g. Set DIP switch according to lightbar length and driver module location as shown below:
h. Apply power to lightbar and verify proper operation.
i. Set Switch #2 on Breakout Box to Down position then to Up position to store configuration into new driver module
j. Verify DIP switch settings if lightbar does not function properly, and repeat step 'i' if DIP switch setting is changed
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
S U P E R I O R C U S TO M E R R E L AT I O N S H I P S . S M A RT LY D E S I G N E D L I G H T I N G & E L E C T R O N I C S O L U T I O N S .
8.
LIGHT MODULE WIRE HARNESS LOCATIONS
3 Wire Harness to
Power Distribution PCB
Questions or comments that do not require immediate attention may be emailed to techservices@soundoffsigal.com.
3 Wire Harness to
Power Distribution PCB
IMPORTANT INFORMATION:
Passenger Side End Tub
nForce Lightbar - 24inch 09.13
Advertisement
Need help?
Do you have a question about the NEXUS TECHNOLOGY nFORCE LED Lightbar 24 and is the answer not in the manual?