Table of Contents
Advertisement
7.4 Remote control
Operating mode 'Preprog‐
rammed automatic show'
Operating mode 'Automatic'
A preprogrammed automatic show can only be activated when the unit is operating alone or
as master in a master-slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [MANUAL]. The display shows 'Pr.xx' . Now you can select one of the preprogrammed
automatic shows. Use [+] and [–] to select a value between 'Pr.01' and 'Pr.09' .
Press [SPEED] to adjust the programme speed. The display shows 'SP.xx' . Use [%], [+] and [–] to
select a value between 'SP.01' (slow) and 'SP.FL' (fast).
Press [STROBE] to set the flash frequency. The display shows 'FS.xx' . Use [%], [+] and [–] to
select a value between 'FS.00' (slow) and 'FS.99' (fast).
The automatic mode can only be activated when the unit is operating alone or as master in a
master-slave combination. This setting is only relevant if the device is not controlled via DMX.
Press [AUTO]. The display shows 'AUTO' , the playback of the built-in automatic programme
starts automatically.
Tri Flat PAR Profile 5x3W RGB 25°, 45°
LED PAR
Operating
33
Advertisement
Table of Contents
