Electrical Welding - Volvo Penta D13 Operator's Manual

Maintenance

Electrical Welding

Remove the positive and negative cables from the
batteries, then disconnect all cables connected to the
alternator, EMS and MCC.
Always connect the welder ground clamp to the
component to be welded, and as close as possible to
the weld site. The clamp must never be connected to
the engine or in such a way that current can pass
through a bearing.
IMPORTANT:
After finished welding, re-connect the EVC connector
and the alternator terminals before connecting the
battery cables.
47710406 10-2018 © AB VOLVO PENTA 95