2-8.4 Jp10: Lan Controller Select (85Mr2-L Only); 2-8.5 Jp11: Vga/Agp4X Safeguard - SOLTEK SL-85MR2 Manual

2-8.4 Jp10: LAN Controller Select (85MR2-L only)

Jp10 is a 2-pin jumper for enabling or disabling the on-board LAN
Controller. Setting Jp10 OPEN will allow user to enable on-board LAN
Controller so as to allow user to set up the LAN driver.
Setting Jp10 CLOSED will allow user to disable the on-board LAN
Controller. In such case, user is free to use an add-on PCI LAN card
for the networking.

2-8.5 Jp11: VGA/AGP4X Safeguard

1. Boot system with on-board VGA:
D e f a u l t J p 11 ( 2 - 3 c l o s e d ) i s
designed to assure booting system
with 1.5V on-board VGA or 1.5V
AGP4X add-on card. User can
choose either VGA or AGP4X as
the initial display by changing BIOS
S e t u p ( s e e
Configurations " in BIOS Setup).
However, if 3.3V AGP 2X card is mistakenly inserted for booting the
system, the high voltage will burn the 1.5V circuitry on board. Never
use a 3.3V or an unknow AGP card in this case.
2. Boot system with AGP4X add-on card only:
To assure the use of a correct AGP4X card of 1.5V, please set Jp11
to 1-2 closed, resulting in that it will allow only 1.5V AGP 4X card to
boot system. With Jp11 1-2 closed, system cannot boot with on-board
VGA or AGP2X card. In this case, if user cannot boot with an AGP
card inserted in AGP slot, it indicates that the AGP card is a wrong
one. The AGP card should be changed until a 1.5V AGP4X card is
inserted.
Jp10:
LAN Controller Select
(85MR2-L/85MR2-SL only)
1
1-2 open
(default)
LAN controller enabled
1
2-3 closed
LAN controller disabled
" P N P / P C I
29
Chapter 2 Hardware Setup
Jp11:
VGA/AGP4X Safeguard
1
1-2 closed for 1.5V AGP 4X
only; (Warning: 3.3V AGP 2X
card will not boot system.)
1
(Default)
2-3 closed for VGA or 1.5V AGP 4X
only;(Warning: 3.3V AGP card will
cause 1.5V circuit burn.)