Advertisement
Install Cisco NCS 1010 Modules
Step 2
Hold the upper and lower surface of the controller with hands and insert the controller into the slot.
Figure 6: Installing the Controller
1
2
Step 3
Using a screwdriver, tighten the two captive screws to a torque value of 0.65 N-m (5.75 lbs-in).
Install Line Card
Use this task to install the line card into the Cisco NCS 1010 chassis.
Procedure
Step 1
Orient the line card.
Step 2
Align the grooves in both sides of the line card with the slide guides available inside the chassis.
Controller
Captive Screw
Install Cisco NCS 1010 Modules
Install Line Card
7
Advertisement
