Advertisement
Connect AC Power to Cisco NCS 1010
Step 2
Using the handle, slide the PSU into the slot (support the PSU at the bottom with your hand) and push it in
until you hear a click sound; direction of insertion is shown in the following figure. The click sound indicates
that the unit has been latched. .
Note
Figure 1: Installing the PSU
1
Connect AC Power to Cisco NCS 1010
Caution
Install Cisco NCS 1010 Modules
2
The locking latch must be pressed and released only for removing the PSU.
Cisco NCS 1010 relies on the protective devices in the building installation to protect against short circuit,
overcurrent, and ground faults. Ensure that the protective devices comply with local and national electrical
codes.
Install Cisco NCS 1010 Modules
PSU unit
Advertisement
