Hdd Unit Replacement - Sony VideoStore VSR-2000 Service Manual

Multi access video and audio server
Hide thumbs Also See for VideoStore VSR-2000:
Table of Contents

Advertisement

4-5. Power Supply Unit Replacement

4-6. HDD Unit Replacement

Installation Procedures
1. Insert a new power supply unit into the slot and push
the power supply unit as far as it will go.
n
Never give a shock to the HDD when inserting the
power supply unit.
2. Secure the power supply unit with the four screws.
3. Install the front panel. (Refer to Section 4-2-1.)
c
Tighten the screws of power supply unit.
If the power supply unit is not secured completely, the
contact resistance of the power connector will be increased
and may cause parts damage or smoking.
Confirmation After Replacement
1. Turn on the power.
2. Make sure that the POWER indicator lights in green of
the ornamental panel.
4-6 (E)
4-6. HDD Unit Replacement
When the SYSTEM indicator of the front panel flashes in
red and the blue indicator of the HDD flashes in spite that
the HDD is not accessed (A rebuild request for the HDD is
generated.), replace the HDD unit of the corresponding
slot.
The HDD unit can be replaced during the power on.
n
When replacing the HDD unit during the power on, the
following precautions should be followed.
. Be sure to put on the earth-band to establish a ground.
If not, this may cause malfunction.
. Be careful not to give any shock to another HDD.
. Replace the power supply unit within three minutes in
consideration of air cooling effect.
Replacement Part
Please order the BKSH-209G, BKSH-218G or the BKSH-
236G.
4-6-1. When using the BZSR-2000 Trial
Version Supplied in the VSR-2000
For more details, refer to the Operation Manual of the
BZSR-2000.
Stopping the HDD
1. Activate the BZSR-2000.
2
Click "Utility".
3. Click "HDD Hot Swap".
4. Click the "STOP" button in the "Request" column of
the HDD on which "Rebuild" is shown in the "Status"
column.
5. Confirm that the HDD stops rotation.
(The "Rebuild" message in the "Status" column
changes to "STOP" and the "STOP" button of the
"Request" column changes "START" button. Confirm
that the blue indicator on the front HDD stops flashing
and changes to turn on.)
VSR-2000

Advertisement

Table of Contents
loading

Table of Contents