Step 1: Installation; Installing The Unit - Sony NSR 1050H - Standalone DVR - 16 CH Getting Started Manual

Step 1: Installation

Installing the Unit

Before setting up, be sure that the location for
installation provides sufficient space and strength to
support the unit.
For details on installation, refer to the Installation
Manual (separate document).
Preparing Devices
Prepare the following devices based on your intended
use.
• Monitors ×2 (operations/settings; hot spot
monitoring)
• Monitor cable (if necessary)
• Keyboard
• Mouse
• System Controller
• Network cameras
• Network switch
• LAN cable
• Analog cameras (when using an NSR-1050H unit or
an NSBK-A16 expansion)
Installing Devices
Connecting the Monitors
Connect the monitor for operations and settings to
monitor connector 1, and connect the monitor for hot
spot monitoring to monitor connector 2.
For systems with only one monitor, be sure to connect
the monitor to monitor connector 1.
4
Step 1: Installation
Example) When connecting two HDMI monitors
Monitor 1
(operations/settings)
HDMI monitor connector 1
HDMI monitor connector 2
Example) When connecting an HDMI monitor
and VGA monitor (HDMI monitor used for
operations)
Monitor 1
(operations/settings)
HDMI monitor connector 1
RGB monitor connector 2
Caution
• There are restrictions on the combination of monitor
connectors that you can use. Be sure to read
"Connecting a Monitor" and "Monitor Connection
Examples" in the Installation Manual (separate
document) before connecting the monitors.
• When monitors are connected via a monitor switch,
images may not always display. We recommend
connecting monitors directly to the unit.
Monitor 2
(hot spot monitoring)
Monitor 2
(hot spot monitoring)