Table of Contents
Advertisement
4. VIDEO COMPOSITE INPUT PHASE adjustment
(Automatic adjustment)
Preparation
. S1300-1, -3 (B-1)/ENC-62 → ON
. S1300-2, -4 (B-1)/ENC-62 → FF
. Input the composite 100% color bar signal (100/0/100/0)
from the video signal generator.
. Press the [V] key of a personal computer first. Then
press the [4] and [ENTER] keys of a personal comput-
er at the same time to enter the adjustment mode. Check
that the message [Step No. 4] PAL Composite Phase
Adjustment appears on the terminal software display.
Adjustment Procedure
. The adjustment is performed automatically. When the
automatic adjustment is complete, the message "EVR
Value : XX-OK?" appears.
. SCH must be adjusted to the center.
Setting after Adjustment
. Press the [ENTER] key of a personal computer and
save the result of adjustment in EEPROM.
. Press the [SPACE] key of a personal computer and
quit the adjustment mode.
. Return S1300 to the original setup (1 : ON/2, 3, 4 :
OFF).
VSR-2000
http://getMANUAL.com
5. VIDEO COMPONENT INPUT Y level
adjustment
Preparation
. S1300-1, -3 (B-1)/ENC-62 → ON
. S1300-2, -4 (B-1)/ENC-62 → FF
. Input the component 100% color bar signal (100/0/100/
0) from the video signal generator.
. Press the [V] key of a personal computer first. Then
press the [5] and [ENTER] keys of a personal comput-
er at the same time to enter the adjustment mode. Check
that the message [Step No. 5] PAL Y Gain Adjustment
appears on the terminal software display.
Adjustment Procedure
Adj. Point : [J] (Down)/[K] (Up) key /keyboard of a
Spec. :
Setting after Adjustment
. Press the [ENTER] key of a personal computer and
save the result of adjustment in EEPROM.
. Press the [SPACE] key of a personal computer and
quit the adjustment mode.
. Return S1300 to the original setup (1 : ON/2, 3, 4 :
OFF).
5-4. ENC-62 Board Adjustment (BKSR-2021)
personal computer
EVR Value : XX Y LEVEL MAX : A
(Displayed on the terminal software display.)
A = 235 ± 1
5-23 (E)
Advertisement
Table of Contents
