Connecting The Keyboard, Mouse And Remote Control Unit; Connecting The Power Cord - Sony NSR 1050H - Standalone DVR - 16 CH Installation Manual

Recommended connector use while operating
the unit
Monitor Connectors to use
HDMI
monitor
connector
1
One HDMI
a
monitor monitor
Analog
–
RGB
monitor
Two HDMI
a
monitor × 2
monitors
Analog
–
RGB
monitor × 2
HDMI
a
monitor and
Analog
RGB
monitor
–
Notes
• There are three monitor connectors labeled "1"
(analog RGB ×2; HDMI ×1) and two monitor
connectors labeled "2" (analog RGB ×1; HDMI ×1),
but only one of each (1 and 2) can be used at any one
time.
• Do not turn on the unit while monitors are connected
to analog RGB monitor connector 1 on both the front
and rear of the unit.
• When operating the unit with only one analog RGB
monitor, do not connect the monitor to analog RGB
monitor connector 1 on the front of the unit while the
unit is turned on.
• When connecting two analog RGB monitors, do not
use the HDMI monitor connectors.
• When using HDMI monitors, be sure to connect the
HDMI monitor and turn it on before turning on the
unit.
• Observe the following restrictions when using analog
RGB monitor connector 1 on the front of the unit.
- Do not connect monitors to HDMI monitor
connector 1.
- Do not connect to analog RGB monitor connector 1
on the front and rear of the unit at the same time
while the unit is turned on. The monitors will not be
recognized if both connectors are used.
• When monitors are connected via a monitor switch,
images may not always display. We recommend
connecting monitors directly to the unit.
16
Step 2: Connections
HDMI Analog Analog
monitor RGB RGB
connector monitor monitor
2 connector connector
1 2
– – –
– a –
a
– –
– a a
– – a
a a –
Connecting the Keyboard, Mouse
and Remote Control Unit
Connect the devices to the USB connectors on the front
and rear of the unit.
Example) When connecting to the USB connectors on
the rear
Keyboard
Notes
• This unit supports IP Desktop USB controllers from
CH Products. Other remote controllers are not
supported.
• When using USB devices, be sure to read "Precautions
for using USB devices" (page 4) in the "Usage
Precautions" section beforehand.

Connecting the Power Cord

Connect the power cord to the power supply connector.
Attach the safety clip to prevent the power cord from
disconnecting.
Mouse
Remort control