Table of Contents
Advertisement
3.
System Operation & Usage
3.1 Connecting the Input
(1) The input connector is located at the right side of the rear panel.
(2) The power cord must be at least 85°C rated.
(3) The thickness of power cord must be between 12AWG to10AWG.
(4) See Figure 3-1 and follow the steps below for the assembly:
Remove the safety cover of input terminal from the DC Power Supply rear panel.
a.
a.
Remove the cable sleeve on the tip for 1cm and tin it.
b.
Plug in the power terminal and secure it with Phillips Screwdriver.
c.
Lock the safety cover to avoid electric shock.
d.
Tighten the latch on safety cover to prevent the power cord from falling or exposing
the charged terminal.
Figure 3-1 Connecting AC INPUT Wires for 62000B-6-1
There is no Breaker or Switch for the system input; therefore it activates
when power is input. As to output, it is determined by front panel
switch.
To cope with the various requirements from customers, the 62000B Series Power Supply
has 3 kinds of on/off operating modes based on the interface used. All of them can operate
the system via 1. Manual on/off, 2. External trigger on/off and 3. Remote on/off. Customers
can choose to use one of it with the following precautions in mind.
1.
In initial state the DC power output is determined by the ON/OFF Switch on the
MAINFRAME front panel.
2.
If the ON/OFF Switch on the Mainframe front panel is ON but the DC Output is OFF, it is
necessary to turn the Mainframe ON/OFF Switch to OFF then ON again to switch the
DC Output to ON.
System Operation & Usage
3-1
Advertisement
Table of Contents
