Manufacturer's Information; Delivery; Packaging; Transport - GEM RSK Operating Instructions Manual

8 Manufacturer's information

8 Manufacturer's information

8.1 Delivery

● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.

8.2 Packaging

The product is packaged in a cardboard box which can be re-
cycled as paper.

8.3 Transport

1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
3. Hold products > DN 100 horizontally so that the product
can only open upwards.
Correct handling:
Incorrect handling:
GEMÜ RSK

8.4 Storage

1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.

9 Installation in piping

9.1 Preparing for installation

Risk of crushing!
▶ Risk of severe injury.
●
●
The equipment is subject to pressure!
▶ Risk of severe injury or death.
Depressurize the plant.
●
Completely drain the plant.
●
Corrosive chemicals!
▶ Risk of caustic burns.
●
●
Hot plant components!
▶ Risk of burns.
●
Exceeding the maximum permissible pressure.
▶ Damage to the product.
Provide precautionary measures against exceeding the
●
maximum permitted pressures caused by pressure
surges (water hammer).
Use as step.
▶ Damage to the product.
▶ Risk of slipping-off.
Choose the installation location so that the product can-
●
not be used as a foothold.
Do not use the product as a step or a foothold.
●
36 / 44
DANGER
Depressurize the plant before perform-
ing any work on the product.
Observe correct handling procedures.
WARNING
WARNING
Wear suitable protective gear.
Completely drain the plant.
CAUTION
Only work on plant that has cooled
down.
CAUTION
CAUTION
www.gemu-group.com