Asf Motor Removal - Epson Stylus Photo895 Service Manual

EPSON Stylus PHOTO 895/785EPX/915/825

4.2.12 ASF Motor Removal

1. Remove the housing from the printer. (Refer to Section 4.2.1 "Housing Removal")
2. Remove the panel unit from the printer. (Refer to Section 4.2.2 "Operation Panel
removal")
3. Remove the printer mechanism from the printer. (Refer to Section 4.2.7 "Printer
mechanism removal")
4. Remove three nuts (M3 hexagon nut) securing the ASF motor to the ink system
frame.
Hexagon Nut M3
Figure 4-45. Removing of ASF motor
5. Disconnect the ASF motor's connector cable from the CN11 on C408/C498 MAIN
board.
Disassembly and Assembly
6. Remove the ASF motor from the ink system frame.
Pay attention not to damage gears when attaching the ink system
C A U T I O N
unit.
Connect the ASF motor connector cable to the CN11 on C408/
C498 MAIN board. It is recommended to use tweezers or small
pliers since the CN11 is not located near the rear end of Main
board.
Tightening torque for screw
• M3 hexagon nut for ASF motor: 6 +/- 1 kgf.cm
Disassembly
Revision B
99