Table of Contents
Advertisement
[BACKLIGHT CHANGING PRECAUTIONS]
Before changing the backlight, always switch off the GOT power externally
in all phases (when the GOT is connected to the bus, the PLC CPU power
must also be switched off externally in all phases) and remove the GOT
main unit from the enclosure.
Not switching the power off in all phases may cause an electric shock.
Not removing the unit from the enclosure can cause injury due to a drop.
When replacing the backlight, use the gloves.
Otherwise, it may cause you to be injured.
If you should directly touch the plated area of the main unit case with hand,
be sure to wipe off the fingerprint and so on, and install the main unit case.
Otherwise, it may cause a trouble or malfunction or make the EMC
Directives mismatched.
Start changing the backlight more than 5 minutes after switching the GOT
power off.
Not doing so can cause a burn due to the heat of the backlight.
[DISPOSAL PRECAUTIONS]
When disposing of the product, handle it as industrial waste.
DANGER
CAUTION
CAUTION
A-6
Advertisement
Table of Contents
