Reprogramming The Command Reverse Unit To Restore Features; Catenary Operation - Lionel Interurban (M.U.) Car Owner's Manual

TrainMaster Command operations

Reprogramming the Command reverse unit to restore features

D ue to the inevitable derailments and
static, it is possible that your Command
reverse unit could someday lose its setup
program. The symptom of this condition
would be unresponsiveness in Command
mode. This can be easily remedied by
"reprogramming" your Command reverse
unit using the following steps.
STEP 1: Move the switch on your locomo-
tive from RUN to PGM.
STEP 2: Plug in your Command Base.
STEP 3: Place the locomotive on track,
then turn on power to your track.
STEP 4: Press "ENG", then input the loco-
motive's ID#. Press "SET."

Catenary Operation

I t is possible to wire your Interurban Car to
operate on a catenary (overhead power)
line. The modifications required are
complex and are not covered in detail by
this instruction manual. The leads to the
center rail roller pick-ups must be discon-
STEP 5: Press "ENG," the ID#, "AUX1,"
then press 6 for your locomotive.
STEP 6: Turn off power to your track and
wait ten seconds.
STEP 7: Remove the locomotive from your
track, and move the switch from PGM to
RUN.
STEP 8: Place the locomotive back on
track, then turn power on to the track.
STEP 9: Press "ENG" and the ID#, then
operate as normal.
nected and a separate lead should be
soldered to the underside of the pantograph
mounting stud (inside the body). This lead
then must be attached to the disconnected
pick-up leads.
15