Reprogramming The Command Reverse Unit To Restore Features - Lionel Missile Launch Sound Car Owner's Manual

TrainMaster Command Control operations

Reprogramming the Command reverse unit to restore features

D ue to the inevitable derailments and static, it is possible that your Missile Launch Sound
Car could someday lose its setup program. The symptom of this condition would be
unresponsiveness in Command mode. This can be easily remedied by "reprogramming" your
Command reverse unit using the following steps.
STEP 1: Slide the Command switch to the PROGRAM position. See Figure 2 on page 5.
STEP 2: Plug in your Command Base.
STEP 3: Place the Missile Launch Sound Car on track, then turn on power to your track.
STEP 4: Press ENG, then input the ID#. Press SET.
STEP 5: Press ENG, the ID#, AUX1, then press 8 for your locomotive.
STEP 6: Turn off power to your track and wait ten seconds.
STEP 7: Slide the Command switch to the RUN position.
STEP 8: Place the Missile Launch Sound Car back on track, then turn power on to the track.
STEP 9: Press ENG and the ID#, then operate as normal.
14