Running Your Interurban Car In The Trainmaster Command Environment; Cab-1 Commands For Your Interurban Car - Lionel Interurban (M.U.) Car Owner's Manual

TrainMaster Command operations

Running your Interurban Car in the TrainMaster Command environment

Example
Address Locomotive #1
Set PowerMasters to CMD or traditional
power supplies to full throttle
Press ENG
Press 1 (the ID#)
Throttle up/press any command button

CAB-1 commands for your Interurban Car

Front coupler releases.
Coupler release
sounds.
Rear coupler releases.
Coupler release
sounds.
Activates keypad.
Air release
sound.
Press AUX2 to turn
your Interurban
Car's headlights on
and off.
Turn the THROTTLE
to the right to
accelerate, left to
decelerate.
Press HALT to shut down
all PowerMaster electri-
cal output on your
railroad. Stops all
Command-equipped
locomotives in operation.
Use HALT only in
Note!
emergency situations.
Y our Command-equipped
Interurban Car comes factory-
programmed with an ID# of "1." To
get your Interurban Car in action, set
PowerMasters to CMD or set all power
supplies on full (no more than 20
volts). Press ENG and "1" on your
CAB-1. Turn the throttle or press any
command button; your Interurban Car
is ready for Command operations.
discontinue. MultiHorn horn
sound.
throttle up, and the locomotive will
accelerate in the opposite direction.
T
HERE IS NO NEUTRAL STATE
release sound.
Interurban Car's previous speed.
return to the previous speed.
Squealing brake sounds.
11
Press WSTL/HRN to
activate the Interurban
Car's horn, release it to
Press BELL to activate
the bell. Bell
ringing.
Press DIR—the locomo-
tive decelerates to a
complete stop; turn the
. Air
Press and hold BOOST for
extra power. Release
BOOST and return to the
Press and hold BRAKE to
slow down or stop.
Release BRAKE and
Beneath this panel
SET L M H