Horizon Fitness 7.4AT Owner's Manual page 10

ASSEMBLY STEP- UNPACKING
BASE FRAME
RED TRANSPORT CABLE
(LEFT & RIGHT SIDES)
A Place the treadmill carton on a level flat surface with the bottom of the box on the ground.
B Cut banding straps on outside of box and remove box lid.
C DO NOT lift treadmill out of the box. Instead, tear down corners of bottom of treadmill box as
shown. Treadmill should be assembled on flattened treadmill box as shown to protect floor surface.
D Cut the banding straps inside the box and remove everything but the treadmill frame.
E Partially lift the running deck upward from the rear to remove all contents from underneath the
running deck. Red transport cables on either side of treadmill will prevent the treadmill deck from
fully lifting.
10
BANDING STRAP
DECK FRAME
RED TRANSPORT
CABLE
RED TRANSPORT
CABLE
WARNING
NEVER tip treadmill upside-
down or on its side. DO
NOT use tools to remove
the red transport cables
until instructed to do so.
If a component requires
tools to remove, wait until
the Assembly Instructions
instructs you how to safely
remove the component.