Panasonic HG-F Series User Manual page 31

"3.3 Adjusting the beam axis"
5.
Beam axis adjustment (if the spot beam does not hit the workpiece)
1. Adjust the beam axis so that the laser spot beam hits the location to be measured on the
workpiece.
2. If necessary, set to the emitted beam spot check mode so that laser spot beam can be
more easily observed.
"3.3 Adjusting the beam axis"
"4.1.2 Emitted Beam Spot Check Mode"
6.
Setting up the functions
Perform the necessary function settings according to application.
"5.1 List of Setting Items"
7.
Threshold judgment
Perform teaching using the master workpiece.
It is also possible to set threshold values.
"5.9 Sensing Output Setting (Teaching)"
8.
Start measurement
Measurement is started. Check the measured values and indicators on the digital display.
"4.2 Operation Check"
"2.2 Description of Parts"
9.
Fine adjustment
Perform fine adjustment on threshold values as necessary.
"5.2 Threshold Fine Adjustment"
WUME-HGF1UM-2
Ramco Innovations www.ramcoi.com Got Questions? Phone 800-280-6933 Email nsales@ramcoi.com
4.1 Basic Setup Procedure
4-3