Taylor 793 Operator's Manual page 19

Step 3
Take one of the scraper blades and slip it under the
hook at the front of the beater. Wrap the blade
around the beater, following the helix and pushing
the blade down onto the helix as you wrap. At the
back end of the beater, slip the blade under the
hook. Repeat this step for the second scraper
blade.
Figure 8
Step 4
Holding the beater securely, slide the beater one
third of the way into the freezing cylinder. Looking
into the freezing cylinder, align the hole at the rear of
the beater with the flats on the end of the drive
shaft.
Figure 9
Model 793
Step 5
Slide the beater the remainder of the way into the
freezing cylinder and over the end of the drive shaft.
The beater should fit snugly, but not so tightly that
the beater cannot be turned slightly to engage the
drive shaft. If the beater slides in too easily with little
or no resistance, there will not be enough force
against the beater to hold the blades in place. If this
is the case, contact your authorized Taylor service
technician.
Repeat steps 1 - 5 for the other side of the unit.
Step 6
Place the large rubber gaskets into the grooves on
the back side of the freezer door.
Step 7
Slide the white plastic front bearings over the baffle
rods onto the bearing hubs, making certain that the
flanged end of the bearing is resting against the
freezer door.
Note: Do not lubricate the gaskets or the front
bearings.
15
Figure 10
Operating Procedures