Network/Imd Settings - Canon DP-V2730 Operation Manual

OSD Menu

Network/IMD Settings

Sub Menu
LAN
68
Configure an IP
Address
Display
Subnet Mask
Web
Control
User ID
Password
Display Setting Link
Configures video display's network settings.
• Cannot be set when [Power on Setting] is [User 1] to [User 3].
Automatic
[Automatic]: Configures an IP address automatically with DHCP/Auto IP.
Manual [Manual]: Configure an IP address and subnet mask manually.
192.168.0.1
255.255.255.0
Settings for operating this device remotely using a Web browser. (
On, Off S et whether or not to receive control signals from an external device,
connected using network connection, in order to operate the video display
remotely from the device's web browser.
Enter the user ID. This is set using up to 16 alpha-numerical characters and symbols. The default
user ID is [user].
E nter the password. This is set using between 8 and 16 alpha-numerical characters and symbols.
The default password is the serial number. The serial number is the individual 12-digit number
assigned to your product, and can be checked on the [System Information] screen.
Adjustment Settings are linked between displays connected via LAN. This device's
Channel setting values are applied to all linked displays.
Adjustment/Channel
* Before linking settings, check that the following conditions are met.
Off
a Turn on the power to this display and the display(s) to link with, and
b Change the adjustment or channel and check that the other display(s)
The devices and firmware versions that can be linked are shown below.
DP-V1830: Version 1.1 or higher
DP-V2730: Version 1.0 or higher
Displays not connected can be removed with the RESET button.
• Operating the buttons on this display will reflect setting value changes
in all. Linked operations using Payload ID, HDMI, Camera, etc. will not
reflect the settings changes.
• If a display model has functions with different menu settings or setting
ranges, some settings will not be correctly exported (settings will not be
changed, will revert to factory defaults, etc.)
• In an environment where communication cannot be done properly,
such as when the network environment is unstable or the bandwidth is
insufficient, settings may not link properly. Only connect displays to be
controlled to the LAN. If a Display Controller is connected, it may not
operate properly.
• If the setting of the display to link with is [Picture Mode] [Type] [Quad]
or [Dual], it may not operate.
• Up to 3 displays can have their settings linked.
Setting Options (Bold: factory default)
check that they are all recognized on the network
also change
18)