Canon DP-V2730 Operation Manual page 46

OSD Menu
Sub Menu
Line Color
46
Line Brightness
Safety Zone Marker 1, 2
Enable
Aspect Ratio
Area Size
Rate (%)
Width (dot)
Height (dot)
White, Red, Green,
Blue, Yellow, Cyan,
Magenta, Gray
High, Low, Half
1
There are two types of [Safety Zone Marker]: 1 and 2, which share the same settings. A safety zone
marker is used to set the safe zone of the image (actual displayed area) to check the image.
On, Off
16:9, 15:9, 14:9, 13:9,
4:3, 2.39:1, 2.35:1,
1.896:1, 1.85:1, 1.66:1,
Variable
• When Variable is
selected
1.00:1 to 3.00:1
80%, 85%, 88%, 90%,
93%, 95%, Variable (%),
Variable (dot)
50 to 100
20 to 3840
20 to 2160
Setting Options (Factory default)
Sets the color of the aspect marker line.
Sets the brightness of the aspect marker line.
Switches the safety zone marker On, Off.
Sets the aspect ratio of the safety zone marker.
[Variable]: The aspect ratio can be entered as a numeric value (0.01:1
increments). The grayed out slider becomes active and can be used
to set the aspect ratio.
• When [Area Size] is set to [Variable (dot)], you cannot select [Aspect Ratio].
Sets the safety zone marker area size.
[Variable (%)]: The grayed out [Rate (%)] becomes active.
[Variable (dot)]: The grayed out [Width (dot)] and [Height (dot)] become
active.
When [Area Size] [Variable (%)]
Move the slider to set the displayed marker area size without changing the
aspect ratio in 1 % increments.
When [Area Size] [Variable (dot)]
Move the slider to set the area width in 2 dot increment.
When [Area Size] [Variable (dot)]
Move the slider to set the area height in 2 dot increment.