Advertisement
Operations
Normal Operation
Using the wired remote, press and hold the 'Up' button to raise the table lift. To lower the table lift, press and hold the
'Down' button. The 'Up' and 'Down' buttons are momentary controlled, when they are released, the table lift will stop
immediately.
To set a preset location, move the table lift to the desired height. Press the 'M' button followed by a numbered button. The
LED display will flash an 'S', followed by an 'S - Number'. This will indicate that the preset has been saved.
To use a preset, press any of the numbered buttons and the table lift will begin to move to the preset position. It is
important to ensure that no obstacles impede the motion of travel. To stop the table lift, press any button.
If the table lift does not function as intended or the LED display flashes "RSt", please follow the Reset Procedure outlined
in the next section.
Setting the LED Display
Using the wired smart remote, retract the table lift to the lowest position. Press
and hold the 'Down' button again until the LED display flashes "RST".
Press and hold the 'M' button until the LED display flashes the starting height (if
the display returns to "RST" before the next step, repeat this step).
To change the value of the starting height, use the 'Up', 'Down' to increase and
decrease by 0.1. Use the '1', '2' to increase and decrease by 1s. Use the '3', and
'4' buttons to increase or decrease by 10s.
Once the correct value is displayed, wait 5 seconds until the LED display
flashes "RST". Follow the Reset Procedure outlined in the above section to save
the new starting height.
Note: the LED display has a tolerance of ±0.1.
Reset Procedure
WARNING: During the Reset Procedure, the table lift will retract 7mm below the lowest normal operating height.
Please ensure that no obstacles impede this motion of travel.
1. Move the desk frame to the lowest position. (If there is "RST" displayed on the
remote, continue to step 3).
2. To initiate the Reset Procedure, press and hold the down button on the remote until
"RST" is displayed. Release the down button.
3. Press and hold the down button on the remote, the desk frame will begin to retract
7mm lower than the lowest normal operating height. Continue to hold the down button
until the frame rises slightly and comes to a stop at the normal lowest position. To stop
motion at any time, release the down button.
4. Once the desk frame has completed the Reset Procedure, the desk height will be
displayed on the remote.
M
M
1
3
P a g e | 10
Advertisement
