Advertisement
Operations
REMOTE BUTTONS
UP - Hold to move table lift up
DOWN - Hold to move table lift down
1
Memory Preset 1
2
Memory Preset 5
3
Memory Preset 3
4
Memory Preset 4
M
Memory Preset programming button
RESET PROCEDURE
WARNING: During the Reset Procedure, the table lift will retract 0.28 inches below the lowest normal operating
position. Ensure there are not obstructions in the path of the table lift. Release the DOWN button to stop motion at any
time.
1. If remote height display shows "ASr", skip to step 4.
2. Move the table lift to the lowest position using DOWN button.
3. Once at the lowest position, press and hold the DOWN button on the remote until
height display shows "ASr". Release the DOWN button.
4. Press and hold the DOWN button, the table lift will move down 0.28 inches below the
lowest normal operating position. Continue to hold the DOWN button until the table lift
moves back up to the lowest normal operating position. Release the DOWN button.
5. The table lift height will be displayed on the remote height display and is now ready
for use.
HEIGHT CALIBRATION
Calibrate the Remote height display to match actual height of desk which may differ depending on feet height or table top
thickness.
1. Move the table lift to the lowest position using the DOWN button. Measure the height from the floor to surface of table
top. If measured height does not match the height on the remote height display, continue with the following steps.
2. Press and hold the DOWN button until height display shows "ASr". Release the DOWN button.
3. Press and hold the M button until the height display flashes.
4. Use the UP and DOWN buttons to match the height display with your measured height.
5. Once the correct value is displayed, do not touch the remote until the height display flashes "ASr". Hold the DOWN
button until the table lift slightly lowers, then slightly rises back up. Release when the table lift height is displayed on the
remote.
Height Display
MEMORY PRESET PROGRAMMING
1. Use the UP or DOWN button to bring the desk to
the desired height.
2. Press M button once, followed by the desired
Memory Preset button.
1
2
3
4 M
P a g e | 9
Advertisement
