Table of Contents
Advertisement
4.10.4
Data Setup
This menu item allows you to set up your radio to transmit and receive data from the external device.
To connect your radio accessory connector to the external device, use the PMKN4159 (Serial) or
PMKN4160 (USB) cable.
The external device must run an application complying with the TETRA standards.
NOTE:
•
Data services are available only in TMO Mode.
•
Data services are blocked in TXI Mode.
•
When set to Voice Only, the built-in data modem is disabled to conserve battery power.
4.10.4.1
Setting Data Function
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Data Setup.
3 Select one of the following options:
•
Voice Only – Your radio receives and transmits voice calls only.
•
Data Only – Your radio acts as a modem. It rejects incoming and outgoing voice calls
(except for Emergency Calls), status and text messages.
•
Voice & Data – Your radio acts as a modem but voice calls have priority over data calls and
can interrupt them.
4.10.5
Audio
This menu item allows you to adjust your radio audio settings.
4.10.5.1
Audio Profiles
An audio profile is a set of audio parameters, such as the volume of alert tones, that are configured by
your service provider to fit a particular operating environment. For example, the audio parameters can
be adjusted to situations when the radio operates inside a building or on a noisy street.
If programmed, the radio displays a name of a currently used audio profile (on the home screen) and/or
an appropriate icon associated with the profile (in the status icon area).
Your service provider can configure a maximum of ten audio profiles.
For a detailed description of a specific audio profile, contact your service provider.
4.10.5.1.1
Setting Audio Profiles
When and where to use: To adjust the audio parameters of the radio in its current operating
environment.
Procedure:
1 From the home screen, press the Menu key.
MN006260A01-AG
Chapter 4 : Main Menu
115
Advertisement
Table of Contents
