Table of Contents
Advertisement
MN006260A01-AG
Chapter 4 : Main Menu
3 Scroll to view the results about the last time your location was calculated.
NOTE: To refresh your position:
•
Select Position – The radio refreshes its position automatically.
•
Press Refresh
4.19.3
Viewing Testpage
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Testpage.
3 Select one of the following options:
•
Position – Displays detailed information on your radio current position: time, N (latitude),
E (longitude), H (height), Sats Used (a number of tracked satellites), B (bearing), HS
(horizontal speed), LC (level of confidence).
•
Power – Displays detailed information on a particular satellite: PRN code, Status, Mode,
C/N (carrier-to-noise ratio).
•
Version – Displays detailed information on software version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
4.19.4
Changing GNSS Accuracy
Procedure:
1 From the home screen, press the Menu key.
2 Select More . . .→Location→Accuracy.
3 Select one of the following options:
•
Medium (default) – Power consumption optimization is combined with less position accuracy.
•
High – Better position accuracy is combined with less power consumption optimization.
NOTE: If connected to an external charging device, the radio automatically enters the
High mode.
4.19.5
Backlog
This sub-menu allows you to enable/disable, view, and delete backlog reports.
NOTE: The location report backlog is only available when Local Information Protocol (LIP) is
enabled.
4.19.5.1
Enabling or Disabling Backlog
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Backlog→Enablement.
3 Select one of the following options:
144
Advertisement
Table of Contents
