Table of Contents
Advertisement
Chapter 2
Getting Started
Familiarize yourself with basic information on how to use the radio.
2.1
Before Power On
Read this section before you power on your radio for the first time.
2.1.1
Attaching the Antenna
Procedure:
1 Insert the screw-in base of the antenna into the antenna terminal on the top of the radio.
2 Turn clockwise until tight.
NOTE: Use only the antenna intended for the radio. Use of other antennas can result in
significant range loss due to poor RF performance.
2.1.2
Installing the SIM Card
Based on the ATEX/IECEx certification, only the following SIM/SD cards are allowed:
•
MM000228A01, 2 GB Industrial Grade MicroSD/MicroSDHC Card
•
DLN6985A, TETRA CRYPTR Micro AES128
•
DLN6986A, TETRA CRYPTR Micro AES256
IMPORTANT: The following procedure must be performed only in non-hazardous environment.
Prerequisites:
Your radio is equipped with a SIM/microSD card slot.
Prepare T-5IP TORX – PLUS screw bit and 1.0 +0.1/-0.1 in-lbs torque screwdriver.
MN006260A01-AG
Getting Started
21
Advertisement
Table of Contents
