MN006260A01-AG
Chapter 4 : Main Menu
4 If needed, enter a PIN code or a passkey.
NOTE: If you enter an incorrect PIN code and the subsequent paring attempts take too
long or result in an error message, power the Bluetooth device off and on. The radio
accepts 3 logging attempts.
4.6.4
Devices
This menu item lists all devices paired with your radio and allows you to perform the following
operations:
•
Connect a device.
•
View and change device details.
•
Disconnect a device.
•
Delete a device.
4.6.4.1
Connecting or Disconnecting Devices
Prerequisites: Only pre-approved sensor devices can be used. The service provider is responsible for
configuring the radio to work with specific devices. See
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Devices.
3 Highlight the required device and press Menu/OK. Select Connect/Disconnect.
NOTE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
4.6.4.2
Managing Devices
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Devices.
3 Highlight the required device and press the Menu key.
•
Name – shows the name of the device (up to 32 characters long). The name is editable only
if it has not been pre-set by the service provider.
•
Type – displays the device type. This menu item cannot be configured.
•
Access – defines how the radio behaves during a reconnection attempt after losing
connection to this device:
102
Add Bluetooth Devices on page
150.