Table of Contents
Advertisement
MN006260A01-AG
Chapter 2 : Getting Started
11 Apply pressure on the SIM card door and use the Torx driver with T-5IP TORX – PLUS bit to
fasten the SIM card door screws to the chassis with torque setting of 1.0±0.1 in-lbs (0.113±0.011
Nm).
IMPORTANT: Ensure that the SIM card door is firmly screwed and the grey SIM card
door O-ring cannot be seen.
12 Install the battery.
2.1.3
MicroSD Card
The microSD card is supported only by radios equipped with a SIM/microSD card slot. The slot is
located under the battery at the back of the radio. If the SIM/microSD card slot is not available, the
radio uses its internal flash memory to store data.
NO SD card can mean both:
•
no physical SD card fitted.
•
SD card fitted is not accepted/recognized.
NOTE:
The radio only supports the following characters to compose file names:
1 Numeric digits.
2 English alphabetic characters.
3 Space.
4 Non-alphabetic characters: ! # $ % & ' ( ) - @ ^ _ ` { } ~.
Before using non-alphabetic characters, make sure your computer system supports them.
To achieve the best radio performance, use microSD cards with the minimum write speed of at
least 6 MB/s (Class 6 or higher). Cards with the write speed lower than 6 MB/s slow down the
performance of the radio.
2.1.3.1
Installing the MicroSD Card
Based on the ATEX/IECEx certification, only the following SIM/SD cards are allowed:
•
MM000228A01, 2 GB Industrial Grade MicroSD/MicroSDHC Card
•
DLN6985A, TETRA CRYPTR Micro AES128
24
Advertisement
Table of Contents
