Advertisement
OPERATING INSTRUCTIONS
Connecting the LP gas cylinder to the grill
The LP Gas Cylinder must be a 20 pound cylinder and have a Type 1 Cylinder Valve Outlet
●
Connector.
Handle the Cylinder with care - do not drop it.
●
When you are not using the grill, the LP Gas Cylinder should be dis-
●
connected.
Connect the regulator and hand tighten firmly.
●
Do a leak test each time you connect a LP Gas Cylinder and before
●
lighting the grill.
Never use a match or lit flame to test for leaks.
●
To test, prepare a weak solution of detergent and water. Spray or
●
swab the solution onto the connection of the regulator to the LP
Gas Cylinder valve, and on all the joints in the hose connections up to the burner valves
(which MUST be closed in the "OFF" position).
Open the LP Gas Cylinder valve, and watch for any bubbles to appear at all the connection
●
points. No bubbles indicate - All Clear!
If there are any bubbles, there is a leak which must be fixed.
●
Never obstruct the flow of combustion and ventilation air.
●
Lighting the grill
Always open the Lid before lighting the grill.
●
All burner knobs should be in the "OFF" position.
●
Slowly Open the LP Gas Cylinder valve,1-1 1/2 turns
●
Push the burner control knob in fully, and slowly turn it counter-clockwise (to the left) to the
●
"LIGHT" position.
Then press and hold the black button of the igniter, there will be clicking and sparking until
●
the burner is lit.
You can then adjust the knob to your desired setting.
●
If the burner did not light, turn the knob back to the "OFF" position, wait 5 minutes for any gas
●
to clear away, and then repeat the lighting procedure.
For Side Burner, turn the knob counter-clockwise (to the left) and then PUSH the Black Igniter
●
Button to light the burner. If the burner does not light ,then turn the knob to the "OFF" posi-
tion, wait 5 minutes and then try again.
After using the grill, - turn all burner knobs to the "HIGH" position and then push
●
fully in and turn to the "OFF" position.
At once turn the valve on the LP Gas Cylinder OFF.
●
IF the igniter does NOT light the burner, you can light it with a
●
match or a piece of burning paper - hold the match or paper
with the Match Holder attached at the back of the grill, put it
through the openings in the Cooking Grid and next to the
Flame Tent covering the burner. Then follow the lighting pro-
cedure above.
Observe the proper burner flame - it should be a blue/yellow color about 1/2" long.
●
Good Flame
24
Bad
YELLOW
BLUE
Burner
Advertisement
